View Larger
 
 


  

  
 

Transmission Rear Housing Support, Transfer Case Brace, LB7/LLY/LBZ, 2001-2007


Fits '01-'07 Allison 4x4 Transmissions (Including the 8.1 L Engine).  . This support can keep your Allison four wheel drive housing from cracking in the event of a driveline vibration (bad u joint, dented or bent driveshaft).
Part Number: 10186  
Fits '01-'07 Allison 4x4 Transmissions (Including the 8.1 L Engine).  . This support can keep your Allison four wheel drive housing from cracking in the event of a driveline vibration (bad u joint, dented or bent driveshaft).
 
Price:
$149.99
Qty: 
 
Fits '11+ Allison 4x4 Transmissions. This support can keep your Allison four wheel drive housing from cracking in the event of a driveline vibration (bad u joint, dented or bent driveshaft).



OVERVIEW

Piece of Mind:
Drive line vibrations from a bad u-joint or other factors can put stress on the 4x4 transmission housing and cause it to crack. Replacing a housing can cost over $1000. Installing a rear housing support can keep your four wheel drive housing from cracking
Built to last:
Our Rear Housing Supports are fabricated in house right here at Merchant Automotive. Using 7/8 .120 wall DOM mild steel tubing for maximum support.


Easy to Install::
The support installs using the factory bolts. This brace can be easily installed in the driveway or garage .




As seen on Two Guys Garage





As seen on Truck U


 Average Rating:  5 Star Rating
5.0
 based on 1 Customer Reviews  
Write A Review
   Solved the problem, August 1, 2017  By Anonymous (LONGMONT, CO)(Verified)
I have the 8.1 L and was having problems with a slight shimmy when the trans was under stress. This solved the problem. However, I will say that this site indicates the installation is easier than it actually is. This bracket mounts on the top of the transmission and some of the bolts are difficult to see in a driveway install. Once I figured that out it took about an hour to install.